Furniture

The chair legs can detach unexpectedly causing the chair to collapse, posing a fall hazard to consumers.

The play yard's side rail can fail to latch properly and when a child pushes against the rail it can unlatch unexpectedly, posing a fall hazard to children.

Carbon dioxide (CO2) pressure sensors inside these products can crack and leak or burst causing the release of CO2. This could cause cracks with sharp edges that could cut a consumer's hand, or direct CO2 discharge could cause a frostbite-like burn to a consumer's hand.

The leg straps in the seat of the float can tear, causing children to unexpectedly fall into or under the water, posing a risk of drowning.

The brew basket can shift out of alignment allowing hot water to overflow. This poses a scalding and burn hazard to consumers.

The refrigerator's doors can detach, posing an injury hazard to consumers.

The loungewear garments fail to meet children's sleepwear federal flammability standards which require sleepwear, including loungewear, to be either snug-fitting or flame resistant.

The bunk beds do not have sufficient headboards, footboards, or guardrails and have gaps between parts of the upper bunk that could allow a child's body to pass through but not a child's head. These bunk beds pose a fall, entrapment, and strangulation hazard to children and violate the spacing requirements of the federal bunk bed safety standard.

This toy chair legs can bruise, pinch or cut fingers if caught while folding.

The play yard's rocking bassinet attachment can tilt even when secured by straps in the non-rocking mode or can stay tilted without returning to a level sleeping surface while in the rocking mode, causing an infant to roll to the corner or side of the bassinet. The infant can then become wedged in the corner or pressed against the side or bottom of the bassinet, posing a risk of suffocation or positional asphyxiation.

The utility vehicle's throttle cable can lock in freezing temperatures. This can cause the engine not to return to idle when the driver takes his or her foot off the accelerator pedal, posing a risk of loss of vehicle control and injury to the driver and passenger.

The side supports on these chairs can splinter when weight is placed on them, posing a fall hazard to consumers.

One or more rails can collapse unexpectedly, posing a fall or entrapment hazard to young children.

Plastic caps and metal screws on both sides of the high chair can loosen and fall out, allowing the seatback to suddenly fall back or detach from the high chair. Children can fall backwards or fall out of the high chair and suffer bumps and bruises to the head, broken bones, abrasions, cuts and bruises. Detached hardware also poses a choking hazard to children.

Recline fasteners and metal screws on both sides of the high chair can loosen and fall out, allowing the seatback to detach or recline unexpectedly. Children can fall backwards or fall out of the high chair and suffer bumps and bruises to the head, abrasions, cuts and bruises. Detached hardware also poses a choking hazard to children.

The sides of the crib are made of mesh that expands, creating a gap between the side and the crib's mattress if it's not zipped into place, or a gap between the side and an added mattress. A young child can slip into this gap and become entrapped or suffocate. Also, the crib's drop side can fail to fully latch posing a fall hazard to young children.