Other Medical Devices

The product has a non-conformity that may cause clips to mislead, jam or fall out of the applier.

The devices have an incorrect firmware configuration.

After a receiving a customer complaint for incorrect labeling, BD has confirmed that a portion of SPS tubes associated with catalog 364960, lot 6090812 were incorrectly labeled at the case and shelf pack level.

The devices have an incorrect firmware configuration.

The devices have an incorrect firmware configuration.

The recommended storage temperature on the label is incorrect.

The devices have an incorrect firmware configuration.

Elute may become colored due to the residual presence of heme group origination from hemoglobin present in whole blood samples as well as dried spot (DBS) samples. This can potentially cause the inhibition of PCR reactions and result in an uninterpretable test result. If using an Internal Control (IC) in the extraction process the IC could potentially be inhibited as well and invalidate test results.

Custom surgical kits were manufactured with part #63310 Catheter Urethral 10FR 16" which were subsequently recalled by CR Bard for a potential sterile barrier breach.

The inner and outer labels on the product contain incorrect reference number of 9-202-3751DS. According to Northgate Technologies, the resistor in the probe will not allow the mislabeled product to be used with the incorrect generator. Could Delay Care.

Biosense Webster, Inc. has recently received an increased number of complaints related to the display of Alert 402 on the CARTO 3 System for certain lots of THERMOCOOL brand catheters. Alert 402 implies a "Map: magnetic distortion" when connected to CARTO 3 System. This issue may subsequently lead the physician to ablate in an unintended area when delivering RF energy.

Alcon is initiating a medical device recall, after receiving notification from a supplier of a recall for x-ray detectable sponges. The one product referenced in the supplier recall notification, is used within Alcon Custom Paks.

In some systems, the unit continues to emit RF energy after the PAUSE button is pressed.

Biosense Webster, Inc. has recently received an increased number of complaints related to the display of Alert 402 on the CARTO 3 System for certain lots of THERMOCOOL brand catheters. Alert 402 implies a "Map: magnetic distortion" when connected to CARTO 3 System. This issue may subsequently lead the physician to ablate in an unintended area when delivering RF energy.

Incomplete and/or partial deployment of the CTAG Device during the endovascular procedure.

The torque wrench used to tighten system bolts during installation was found to be out of tolerance

Incorrect source step size may occur in the software plans

There is potential that fluorescent platelet (PLT-F) and immature platelet fraction (IPF%, #) results obtained using the lots listed above may exhibit lower than actual PLT-F and IPF values. The issue may be recognized by a large discrepancy between the impedance platelet (PLT-I) result and the PLT-F result. In most cases, the falsely decreased PLT-F results display a PLT Abn Scattergram message with an asterisk beside the result or an Action Message: Difference between PLT and PLT- F. Check the results. These are indicators of unreliable data. In rare instances, platelet flags may be absent. The PLT-I results are unaffected.

Beckman Coulter has identified that due to a PLC software nonconformity the 1K Stockyard can initiate a retrieval of a sample tube during the rack loading process, which should not occur. This issue and associated complaint were discovered and filed internally.

During a bolus tracking procedure, no images were generated when the scan was completed, and the raw data file was not available for offline reconstruction. There is a discrepancy between the calculated reconstruction length and the actual scan length that results in the inability to reconstruct raw data. The operator may choose to rescan the patient.