Olympus Scientific Solutions Americas Corporation ( OSSA ) Model: VANTA Analytical X-Ray System
Class I - DangerousWhat Should You Do?
- Check if you have this product: Model - Vanta VCR
- Do not eat it: Even if it looks and smells fine, do not consume this product.
- Throw it away or return it: You can return the product to the store for a full refund.
- Seek medical attention if needed: If you've consumed this product and feel unwell, contact your doctor immediately.
- Report problems: Report any issues to the FDA's Safety Reporting Portal.
⚠️ Emergency: If you experience severe symptoms after consuming this product, call 911 or Poison Control at 1-800-222-1222.
Recall Details
- Company:
- Olympus Scientific Solutions Americas
- Reason for Recall:
- Possible unintentional x-ray emission after users attempt early termination of the sequence.
- Classification:
- Class I - Dangerous
Dangerous or defective products that predictably could cause serious health problems or death.
- Status:
- terminated
Product Information
Full Description:
Olympus Scientific Solutions Americas Corporation ( OSSA ) Model: VANTA Analytical X-Ray System
Product Codes/Lot Numbers:
Model - Vanta VCR
Distribution:
Distributed in: US, TX, WA, GA, MA, SC, AZ, PA, VA, CA, OH, NJ, MD, CO, IL, LA, MN
Official Source
Always verify recall information with the official FDA source:
View on FDA.govFDA Recall Number: Z-0680-2017
Related Recalls
Olympus Scientific Solutions Americas Corporation ( OSSA ) Model: VANTA Analytical X-Ray System, X-Ray Fluorescence
Olympus Scientific Solutions Americas
Instruments may, under certain specific circumstances listed below, fail to stop when a test is initiated and no sample is present (proximity shut down fails to end test).
Olympus Scientific Solutions Americas Corporation ( OSSA ) VANTA¿ XRF Analyzer. Model Vanta VCR and Vanta VMR Analytical X-ray systems
Olympus Scientific Solutions Americas
It was discovered under rare circumstances the LED warning light circuit could fail. If this happens, while the instrument is emitting X-rays during at test, the LED warning lights will not illuminate. The test runs normally and will execute as before, but the light will not be on.
Trigger lock option does not always prevent x-ray generation. Specifically if the unit is in test mode or repeat test mode then the trigger lock may not prevent x-ray initiation when the trigger is pulled. The correction is via repair by a software update.