SHUNT KIT 9733605 NON-INVASIVE
Class I - DangerousWhat Should You Do?
- Check if you have this product: Lot No.: 120628B 130204E 130314H 121113H 130508B 130612A 130709 130325 130710 130729A 130826 130923B 131016C 131025F 130923B 131127A
- Do not eat it: Even if it looks and smells fine, do not consume this product.
- Throw it away or return it: You can return the product to the store for a full refund.
- Seek medical attention if needed: If you've consumed this product and feel unwell, contact your doctor immediately.
- Report problems: Report any issues to the FDA's Safety Reporting Portal.
⚠️ Emergency: If you experience severe symptoms after consuming this product, call 911 or Poison Control at 1-800-222-1222.
Recall Details
- Company:
- Medtronic Navigation, Inc.
- Reason for Recall:
- Medtronic Navigation is recalling certain Medtronic single-use, disposable devices because there was not sufficient control to assure that returned, unused devices were appropriately examined for product and/or package damage to ensure sterility.
- Classification:
- Class I - Dangerous
Dangerous or defective products that predictably could cause serious health problems or death.
- Status:
- terminated
Product Information
Full Description:
SHUNT KIT 9733605 NON-INVASIVE
Product Codes/Lot Numbers:
Lot No.: 120628B 130204E 130314H 121113H 130508B 130612A 130709 130325 130710 130729A 130826 130923B 131016C 131025F 130923B 131127A
Official Source
Always verify recall information with the official FDA source:
View on FDA.govFDA Recall Number: Z-1594-2014
Related Recalls
Due to an increase in complaint that the percutaneous reference pin would not fit into the patient reference frame or percutaneous pin adapter.
Due to two software anomalies that can occur within a spine procedure. Two issues are: 1. Navigation Orientation - when lateral orientation radiographic images are taken, information may appear flipped when utilizing the system (180 degree flipped). 2. Pop-up Message - when using CT+Fluouroscopy images with a slice spacing thickness greater than 2mm, the system does not display a pop-up message indicating the slice spacing is not optimal.
Due to a software issue, there is the potential for a missing digit, letter, or decimal in either the "distance to target" or "tip stop point" display during navigation.