All Recalls

Bezel repair part, not by the original manufacturer, used in the service and repair of Alaris Pump Module Model 8100, may experience cracking and/or separation of the bezel posts. Separation of one or more bezel posts could lead to free flow, over infusion, under infusion, or interruption of infusion.

Products distributed as sterile may not have been adequately sterilized

Products distributed as sterile may not have been adequately sterilized

Cooling Unit (CLU) expelled out of a CT gantry of an iCT system may result in injury

Products distributed as sterile may not have been adequately sterilized

Products distributed as sterile may not have been adequately sterilized

Products distributed as sterile may not have been adequately sterilized

Products distributed as sterile may not have been adequately sterilized

Antigen Rapid Test Kit is not authorized, cleared, or approved for marketing and/or distribution in the U.S.

Products distributed as sterile may not have been adequately sterilized

Products distributed as sterile may not have been adequately sterilized

Products distributed as sterile may not have been adequately sterilized

Products distributed as sterile may not have been adequately sterilized

Products distributed as sterile may not have been adequately sterilized

Products distributed as sterile may not have been adequately sterilized

Products distributed as sterile may not have been adequately sterilized

Siemens identified two issues, In some cases, it is possible to perform an image acquisition although more than 20% of the beam does not hit the detector. This may only occur when an organ program for the wall mode without top alignment is selected and the system is moved to the centred position. If afterwards the operator activates the top alignment, increases the collimation, and lifts the tube, the system allows examination even with the tube being misaligned to the detector position. Hence, it is possible to overshoot the detector by more than 20%. From a clinical point of view, it is highly unlikely for the operator to trigger the examination as the misalignment is visible due to the light field being out of range. AND In very rare cases it may occur that the calculated dose value exceeds the limit of 2 Gy. This may potentially occur only when an organ program for free exposure is selected, and the system uses incorrect (too small) source-to-image distance (SID) for calculating applied dose. Hence, the calculated dose is much higher than the actual applied dose causing the buzzer, which normally notifies the operator about the exceeded limit of 2 Gy, to get activated erroneously.

Products distributed as sterile may not have been adequately sterilized

Products distributed as sterile may not have been adequately sterilized

Software versions 6.0.4 to 6.2.1 using Advanced Reporting -possibility that a previously assigned internal patient database ID can be reused for a new patient. It was discovered that this value does not increase when a patient merge activity is executed in a specific sequence